RRP 379,00€ Original price was: 379,00€.349,00€Current price is: 349,00€.
1 "InstantVap 18V Original" sublimator with electronic thermostat, 1 oxalic acid dispenser, 1 silicone cap (for cleaning), 2 replacement O-rings for the dispenser, 1 safety bag
18 volts, 240 watts, 13 amps
Oxalic acid is extremely dangerous for the human body! Never work without suitable protective equipment! Full protective equipment includes full-body protective clothing, gloves (acid and heat resistant up to 250 °C), eye protection (safety goggles or full face mask), respiratory protection (half mask or full face mask suitable for gaseous oxalic acid). Please note that FFP2 or FFP3 masks are only suitable for oxalic acid in solid form, but not for oxalic acid sublimate, as these have too much leakage in the face area and therefore too much unfiltered air contaminated with oxalic acid is inhaled!
1 Always switch off the heating with the toggle switch before inserting (and removing) the battery.
2. insert the battery.
4 Pull out the oxalic acid dispenser and set the desired amount in grams. Replace the dispenser and push it all the way down.
5 Switch on the heating with the toggle switch. Wait until the vaporiser has reached the set temperature.
temperature has heated up. The heating time is 3 to 5 minutes.
6. wear a full or half mask with protective goggles, gloves and closed clothing before treating with oxalic acid.
7. insert the copper tube at the front of the InstantVap 18V into the hive and press the front of the oxalic acid vaporiser lightly against the outer wall of the hive.
8. pull the oxalic acid dispenser out of the dosing tube and press it firmly into the oxalic acid 2-3 times to fill it.
9. reinsert the dispenser into the dosing tube and press the plunger at the end of the dispenser firmly into place.
10. Wait approx. 25 seconds until the displayed actual temperature rises again.
11. Remove the InstantVap and go to the next hive.
12 Observe the battery indicator on the voltage display and replace the battery in good time.
13 After treating the last hive, switch off the InstantVap 18V Original or the heater using the toggle switch and remove the battery to recharge it immediately.
14 Rinse the dispenser thoroughly under running water and allow it to dry thoroughly.
15 Clean the outside of the oxalic acid vaporiser with a damp cloth.
16 Do not put the InstantVap 18V away until it has cooled down to avoid fire and burns.
The first oxalic acid preparation for vaporisation has now been approved in Germany. The medicine "Varroxal 0.71 g/g beehive powder" from the Swiss company Andermatt BioVet comes in powder form and will be available from 13 November 2023. It can be dripped, sprayed and also vaporised. Click here and get all information on the topic!